English
After performing this function, the USB device is no longer
accessible from your receiver. To gain access to your storage
device again, re-insert it or switch the receiver to standby and
on again.
There may be various reasons for abnormal operation of the receiver. Check the receiver
according to the procedures shown below. If the receiver does not work properly after
checking it, please contact your dealer or the local Service Hotline. Do NOT try to open or
disassemble the receiver. It may cause a dangerous situation and warranty will be void.
LED indicator not lit Mains lead unplugged Check mains plug
No signal found Aerial is disconnected
Aerial is damaged/
misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna
Power ON/connect
external power
No picture or sound on TV
or amplier
HDMI or SCART is not
selected on your TV or
amplier or the unit is set
to higher resolution as the
TV supports.
TV/amplier is not
switched on
Switch to correct TV/
amplier input
Select lower resolution on
receiver
Switch TV/amplier on.
Check if S / PDIF
connection is used.
Scrambled channel
Message
Channel is scrambled Select alternative channel
No response to remote
control
Receiver off
Remote not aimed
correctly
Front panel obstructed
Remote batteries
exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Forgotten PIN code
Forgotten channel lock
code
Default PIN is 1234
Contact local Service
Hotline or send email to
our Support via www.
thomsonstb.net
To Next Page
Loading...
