English
Make sure that the HDMI cable and outdoor components are in a good condition.
Use only a HDMI 1.3 cable or higher for maximum performance.
If you use TV SCART connection, use then well shielded SCART cable.
This manual provides complete instructions for installing and using this receiver. The
following symbols will serve as follow.
Indicates warning information.
Indicates any other additional important or helpful information.
Represents a button on the remote control or the receiver.
Move to Represents a menu item within a window. (Italic characters)
1. User manual
2. 1 remote control unit
3. 2x batteries (AAA type)
The batteries should not be recharged, disassembled, electrically
short-circuited, be mixed or used with other types of batteries.
If rechargeable accumulators instead of batteries are going to
be used (e.g. NiMH), we recommend using types with low self-
discharge to ensure long time operation of your remote control.
It is recommended to use USB 2.0 storage devices or higher. If your device is not
compatible to USB 2.0 specications, recording, playback and other multimedia functions of
the receiver might not work properly.
To ensure best performance of your USB storage device please format it via your receiver
(through the menu “Media”) to FAT32 system. Other le systems are not supported by the
receiver. However, it is possible to use already NTFS formatted disks.
THOMSON cannot guarantee compatibility with all types of USB storage devices.
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
specications may exceed the supported output of your receiver (max.5 V/800 mA). If so,
please connect your USB HDD to an according external power adapter.
It is advised not to store important information on USB storage devices used with the
receiver. Always make backups of data on your USB storage device before using it with this
receiver. THOMSON will not take responsibility for any loss of information or circumstances
caused by loss of information.
Fig.1
1. Indicates current time in STANDBY mode*
Indicates current channel number in OPERATING mode*
2. Point your remote control towards this sensor.
To Next Page
Loading...
