English
19. Toggles between TV or RADIO mode
20. 2 Starts Timeshift
21. 5 6 Fast rewind/fast forward
22. 4 Records the TV programme to the connected USB storage device
23. u Starts playback of a selected le in the media player
24. 7 Back to the previous track during playback
25. 8 Skip to the next track during playback
26. 3 Stops playback of the selected le in the media player
27. Opens the Media Player list
28. Displays Teletext on the OSD (On Screen Display)
29. Shows a list of subtitle languages
30. Change of video resolution
31. No function
Fig.4
To receive broadcasted signals, your terrestrial indoor or outdoor antenna must be
connected to the ANT IN connector on the back of the receiver. Use a properly shielded
antenna cable and suitable connectors.
The ANT OUT connector allows you to loop the antenna signal to a second receiver or
TV set.
Please consider that the looped signal might be too weak if you use an active antenna.
If the signals at your location are too weak to receive proper
signals with an indoor antenna, we recommend using an outdoor
antenna which can be pointed towards the transmission tower.
Ask your local dealer for more information.
Fig.4
The TV set shall be connected with the receiver using a good quality HDMI 1.3 or higher
cable. This connection gives the highest possible quality.
Fig.4
Your receiver is also equipped with a SCART connector; alternatively, the TV set can be
connected to the receiver using a good quality SCART cable.
Fig.4
TV sets without SCART or HDMI input(s) can be connected to THT505 by using suitable
RCA cables. Connect one end of the cable to the Audio L, R and VIDEO connectors on the
back of THT505. Connect the other end to the respective inputs on your TV set.
To Next Page
Loading...
