English
OSD Timeout: Sets the time after which on screen banners and messages
disappear. The range is 1~10 seconds.
OSD Transparency: To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press to clear all OSD settings and reset to default values.
Auto Standby is a new feature that helps you reducing power consumption. When set to
30Min/1 Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn’t receive
any commands during this time. Set Auto Standby to Off to deactivate the automatic
standby function.
Press in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press or u to enter.
Use pq to highlight the submenu of choice and press proceed.
Press to leave.
This submenu shows receiver specic information such as hardware version and software
version. It also displays our web address www.thomsonstb.net. Please have the Information
screen on hand when you call our hotline. The person who answers your call might ask for
the information given in this screen.
This option allows you to reset the receiver to factory settings, which clears all
stored channels.
By resetting your receiver to factory default, all your settings and
stored channels will be permanently deleted. Please use this
option with care.
Use pq to select Load Factory Settings in the Tools menu and press . You are asked to
input your PIN code.
Input the correct PIN code using the . A conrmation window
is displayed.
Select Yes to return to factory settings. Select No to cancel.
Press
to leave.
This receiver is equipped with an Over The Air software upgrade function. An Over The Air
update might not be available in your region. Please visit our website www.thomsonstb.net
or contact your local service hotline for more information about this option.
This feature allows you to upgrade receiver software via the USB port. When new software is
available for your receiver, it can be downloaded from our website www.thomsonstb.net.
Place the software le (unzipped) in the root directory of your USB storage device (HDD,
memory stick etc.) and connect the device to the USB port of the receiver.
To Next Page
Loading...
