© 2013 Thorlabs GmbH184
DCx Cameras
IS_CONFIG_CPU_IDLE_STATES_CMD_SET_DISAB
LE_ON_OPEN
Changes the energy settings of the operating system so
that low power consumption operating states (unequal
C0) are disabled.
Additional information
pParam: Pointer to a UINT variable, see
CONFIGURATION_SEL .
nSizeOfParam: 4
Note: To apply a new setting, you must close all open
DCx Cameras and then reopen at least one camera.
IS_CONFIG_CPU_IDLE_STATES_CMD_GET_DISAB
LE_ON_OPEN
Returns the current setting for
IS_CONFIG_CPU_IDLE_STATES_CMD_SET_DISABLE_
ON_OPEN.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
IS_CONFIG_OPEN_MP_CMD_GET_ENABLE
Returns whether OpenMP support is enabled.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
IS_CONFIG_OPEN_MP_CMD_SET_ENABLE
Enables OpenMP support.
Additional information
pParam: Pointer to a UINT variable,
to enable: IS_CONFIG_OPEN_MP_ENABLE
to disable: IS_CONFIG_OPEN_MP_DISABLE
nSizeOfParam: 4
Note: The settings are lost after the application is closed
and must be set again the next time the camera is
started.
IS_CONFIG_OPEN_MP_CMD_GET_ENABLE_DEFAUL
T
Returns the default setting for OpenMP support.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
IS_CONFIG_INITIAL_PARAMETERSET_CMD_SET
Sets the parameter set to read and apply from the camera
EEPROM when the camera is opened.
Additional information
pParam: Pointer to a UINT variable,
IS_CONFIG_INITIAL_PARAMETERSET_NONE
IS_CONFIG_INITIAL_PARAMETERSET_1
IS_CONFIG_INITIAL_PARAMETERSET_2
nSizeOfParam: 4
IS_CONFIG_INITIAL_PARAMETERSET_CMD_GET
Returns which parameter set will be read and applied
from the camera EEPROM when the camera is opened.
185
186
185
186
185
187
187
185
187
187