© 2013 Thorlabs GmbH122
DCx Cameras
3.4.3.3 Loop Mode
When using the uc480 Player, you can select specific periods of time within the video sequence and play them
back in an endless loop. To do this, click the button. This enables the two icons for marking the start and end
of the playback loop. To select the start position, use the mouse to drag the position marker to the desired start
position in the endless loop and then click the button. Then, set the position marker to the desired end position
using the same method. Click the button to complete defining markers.
3.4.3.4 Video Window and Full Screen Mode
The video window is displayed dynamically. The possible display sizes are determined based on the capture
resolution and the screen resolution.
Note
The video is played back at the same aspect ratio that was used for the capture.
The full screen mode is activated by pressing the keys CTRL+F. In the full screen mode you can control the
playback via the keyboard. You leave the full screen mode by pressing ESC or CTRL+F.
Key combinations in full screen mode
Start/stop full screen mode
Start/stop video playback