EasyManuals Logo

THORLABS DCU223x User Manual

THORLABS DCU223x
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
© 2013 Thorlabs GmbH148
DCx Cameras
4.2.4.3 Image Pre-processing
Bayer conversion
The following functions enable and adjust the Bayer conversion (see Color filter (Bayer filter) ).
is_Convert()
Converts a Bayer raw image into the desired output format
is_GetColorConverter()
Returns the currently set Bayer conversion mode
is_SetBayerConversion()
Sets the algorithm for Bayer conversion
is_SetColorConverter()
Sets the algorithm for Bayer conversion in the camera (not applicable for DCx
Cameras)
Lookup table
Using lookup table (LUT) functions, you can e. g. adjust brightness or contrast after the acquisition.
is_GetCameraLUT()
Read out current hardware LUT
is_GetImageHistogram()
Computes a histogram for the image buffer passed to the function
4.2.4.4 Get Camera Status
Using these functions, you can read out additional useful information on the camera status.
is_CameraStatus()
Returns the event counters and other information.
Enables standby mode.
is_GetAutoInfo()
Returns status information on the auto features.
is_GetCameraList()
Returns information on all connected cameras.
is_GetCameraType()
Returns the camera type.
is_CaptureStatus()
Displays information on errors that have occurred.
is_GetError()
Displays errors that have occurred.
is_GetUsedbandwidth()
Returns the bus bandwidth (in Mbyte/s) currently used by all
initialized or selected cameras.
is_GetVsyncCount()
Returns the VSYNC counter. It will be incremented by 1 each time
the sensor starts capturing an image.
is_SetErrorReport()
Enables/disables dialog messages for error output.
4.2.4.5 Using the Camera EEPROM
The non-volatile EEPROM of every DCx camera can hold user data or camera settings.
is_GetCameraInfo()
Returns the factory-set information (e.g. revision information for the
individual DCxCamera components).
is_GetSensorInfo()
Returns the sensor information.
is_ReadEEPROM()
Reads out the writable data area of the EEPROM.
is_WriteEEPROM()
Writes user data to the EEPROM.
26
188
236
420
315
235
242
172
227
233
385
174
239
257
258
326
231
251
296
358

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS DCU223x and is the answer not in the manual?

THORLABS DCU223x Specifications

General IconGeneral
BrandTHORLABS
ModelDCU223x
CategorySecurity Camera
LanguageEnglish

Related product manuals