© 2013 Thorlabs GmbH
4 Programming (SDK)
205
4.3.18 is_DisableEvent
Syntax
INT is_DisableEvent (HIDS hCam, INT which)
Description
Using is_DisableEvent(), you disable the event indicated here. The event (e.g. image capture completed) will
usually still occur, but will no longer trigger an event signal. Disabled events are no longer signaled to the
application. You can re-enable the desired event using is_EnableEvent() . See also is_InitEvent() .
Input parameters
ID of the event to be disabled. See also
is_EnableEvent() .
Return values
One of the submitted parameters is outside the valid
range or is not supported for this sensor or is not
available in this mode.
Function executed successfully
Related functions
is_EnableEvent()
Windows only: is_InitEvent()
Windows only: is_ExitEvent()
Linux only: is_WaitEvent()
209 276
209
209
276
214
355