THORLABS DCU223x User Manual

© 2013 Thorlabs GmbH
4 Programming (SDK)
291
is_AddToSequence() function.
IS_NO_SUCCESS
General error message
IS_NOT_SUPPORTED
The camera model used here does not support this
function or setting.
IS_SUCCESS
Function executed successfully
Example 1
INT nRet = IS_SUCCESS;
/* Create info object */
MEASURE_SHARPNESS_AOI_INFO measureSharpnessInfo;
/* Set values of AOI_0: The position and size of the AOI equals the whole image */
measureSharpnessInfo.u32NumberAOI = 0;
measureSharpnessInfo.rcAOI.s32X = 0;
measureSharpnessInfo.rcAOI.s32Y = 0;
measureSharpnessInfo.rcAOI.s32Width = m_s32MaxImageWidth;
measureSharpnessInfo.rcAOI.s32Height = m_s32MaxImageHeight;
/* Set AOI_0 */
nRet = is_Measure(m_hCam, IS_MEASURE_CMD_SHARPNESS_AOI_SET, (void*)&measureSharpnessInfo,
sizeof(measureSharpnessInfo));
/* Set values of AOI_1 */
measureSharpnessInfo.u32NumberAOI = 1;
measureSharpnessInfo.rcAOI.s32X = 50;
measureSharpnessInfo.rcAOI.s32Y = 50;
measureSharpnessInfo.rcAOI.s32Width = 200;
measureSharpnessInfo.rcAOI.s32Height = 200;
/* Set AOI_1 */
nRet = is_Measure(m_hCam, IS_MEASURE_CMD_SHARPNESS_AOI_SET, (void*)&measureSharpnessInfo,
sizeof(measureSharpnessInfo));
Example 2
INT nRet = IS_SUCCESS;
/* Create info object */
MEASURE_SHARPNESS_AOI_INFO measureSharpnessInfo;
/* Get values of AOI_0 */
measureSharpnessInfo.u32NumberAOI = 0;
nRet = is_Measure(m_hCam, IS_MEASURE_CMD_SHARPNESS_AOI_INQUIRE, (void*)&measureSharpnessInfo,
sizeof(measureSharpnessInfo));
if (nRet == IS_SUCCESS)
{
UINT s32Sharpness = measureSharpnessInfo.u32SharpnessValue;
}
Example 3
INT nRet = IS_SUCCESS;
/* Set preset */
UINT nPreset = IS_MEASURE_SHARPNESS_AOI_PRESET_1;
nRet = is_Measure(m_hCam, IS_MEASURE_CMD_SHARPNESS_AOI_SET_PRESET, (void*)&nPreset,
sizeof(nPreset));

THORLABS DCU223x Specifications

General

Brand	THORLABS
Model	DCU223x
Category	Security Camera
Language	English