ACTIVITY
28 / 62 07.07.2022
On the way back to the start point, the watch uses the GPS signal to guide you. These data are
permanently calculated, and depend on the GPS signal received. Depending on the environment you
are in, the signal may be lost for a brief moment. In this case, the watch screen displays a flashing
satellite icon, to indicate that "GPS" reception is insufficient to guide you precisely.
If the watch is locked, the following screen will be displayed:
If the GPS signal is lost, it is recommended to stop and wait a few minutes for the signal to return. But
according to the location (e.g.: in an enclosed valley or near steep slopes), there is no point waiting for
this signal to return; in this case it is preferable to continue on the route.
4.2.3 Description of the specific watch icons on the way back
: Activity tracking in progress;
: GPS signals insufficient;
: GPS signals active.
These two similar icons distinguish whether the GPS signal is active or lost.
If the GPS signal is lost, it is recommended to stop and wait a few minutes for the signal to return. But
according to the location (e.g.: in an enclosed valley or near steep slopes), there is no point waiting for
this signal to return; in this case it is preferable to continue on the route.
Note:
These icons are visible only in the top left of the watch screen when it is locked.
4.2.4 Automatic function stop
When you are approaching +/- 50m from your start point, the "BRING ME BACK" function finishes,
and the following message will be displayed on the watch screen:
To Next Page
Loading...
Need help?
General
