Add a transponder: Place the focus on Frequency and press the green but-
ton. Specify the frequency, symbol rate, and polarization.
Edit a transponder: Choose Frequency and select a transponder. Press the
yellow button and then modify the transponder’s details.
Delete a transponder: Choose Frequency and select a transponder. Press
the red button and then confirm to delete it.
Unicable Settings
If the user’s house is equipped with a single cable router, configure unicable
settings properly.
Open the Settings > Installation > Dish Setting menu. Set LNB Type to Uni-
cable and then choose Unicable Setting. Choose Config Mode and deter-
mine whether to scan for all available channels or a specific channel. Specify
the details, such as port and predetermined intermediate frequency.
3.3 Using a Motorized Dish
While a fixed dish usually only picks up one satellite, a motorized dish can
pick up multiple satellites.
There are two control methods for motorized dishes: DiSEqC 1.2 and USALS.
With DiSEqC 1.2, the user must manually operate the dish to locate satellites
one by one. The digital TV receiver stores each satellite position for later use.
With USALS, the receiver can pinpoint all visible satellites through calcula-
tions using the dish coordinates and the built-in database of satellite posi-
tions.
S C 17
To Next Page
Loading...
