• TV Only: Scan only for free and pay TV channels.
To scan for a specific channel, set it to Manual, and then choose Channel
and specify the channel’s number.
If the aerial needs power supply, turn on Antenna 5V.
Select Service Search to start channel scan.
3.6 Scanning Cable TV Channels
Open the Settings > Installation > Cable Search menu.
There are two signal bars on the lower part of the screen. The signal level bar
indicates how strong the signal is, and the signal quality bar indicates how
easy it is to pick up.
To scan for all available channels, set Search Mode to Auto. Choose Search
Type and determine which types of channels to scan for.
• All Service: Scan for all available TV and radio channels.
• FTA Only: Scan only for free TV and radio channels.
• TV Only: Scan only for free and pay TV channels.
To scan for a specific channel, set Search Mode to Manual. Set these options
for the channel.
• Frequency: Specify the channel’s frequency.
• Symbol rate: Specify the channels’ symbol rate.
• QAM Mode: Specify the modulation method used for the channel.
Select Service Search to start channel scan.
S C 23
To Next Page
Loading...
