Using DiSEqC 1.2
Open the Settings > Installation > Dish Setting > Positioner Setting menu,
and then set Positioner to DiSEqC 1.2.
Repeat these steps for every desired satellite.
1. Choose Go to Reference from Positioner Command for the dish to re-
turn to the reference point at the highest point in its arc. The dish’s
movement accuracy may decrease over long-time use. To correct move-
ment errors, choose (Re-) Calculate from Positioner Command.
2. Choose Satellite and choose a target satellite.
3. Choose Tuner and determine which of the dish connectors to use. This
option is not available when Tuner Connection is set to Loop-Through
under Settings > Installation > Dish Setting.
4. Choose Frequency and select any available transponder.
5. Choose Go to Stored Position from Positioner Command to rotate the
dish, so that it faces the target satellite.
6. Place the focus on Move and press the left or right navigation button
to finely drive the dish east or west for the best signal. The dish rotates
continuously as long as either of these buttons is held down.
7. Choose Store Satellite Position from Positioner Command to save the
dish’s current position for the target satellite.
18 3.3 U M D
To Next Page
Loading...
