• Transmission: Specify the modulation method used for the transponder.
DVB-S2 is usually used for HD channels.
Make sure that the common options are properly configured before select-
ing Service Search to start channel scan.
Scanning for One Channel
To scan for only one specific channel, set Search Mode to Advanced. Each
satellite TV channel has unique packet IDs used to distinguish between
channels. In addition to the information about a target transponder, users
need to know what packet IDs a target channel uses.
• Video PID: Specify the channel’s video packet ID.
• Audio PID: Specify the channel’s audio packet ID.
• PCR PID: Specify the channel’s PCR (programme clock reference) packet
ID. This is usually identical to video PID. If the video PID setting doesn’t
work, try 8191.
Make sure that the common options are properly configured before select-
ing Service Search to start channel scan.
3.5 Scanning Terrestrial TV Channels
Open the Settings > Installation > Terrestrial Search menu.
There are two signal bars on the lower part of the screen. The signal level bar
indicates how strong the signal is, and the signal quality bar indicates how
easy it is to pick up.
To scan for all available channels, set Search Mode to Auto. Choose Search
Type and determine which types of channels to scan for.
• All Service: Scan for all available TV and radio channels.
• FTA Only: Scan only for free TV and radio channels.
22 3.5 S T TV C
To Next Page
Loading...