It may be useful to set limits to the movement scope of the dish for easier
manipulation. Repeat these steps two times to set a limit position for the
east and the west.
1. Choose Go to Reference from Positioner Command for the dish to re-
turn to the reference point.
2. Place the focus on Move and press the left or right navigation button to
drive the dish.
3. Choose Set East (soft) Limit or Set West (soft) Limit from Positioner
Command to save the dish’s current position to use it as a limit position.
Choosing Disable (soft) Limits from Positioner Command clears these limit
positions.
Using USALS
Open the Settings > Installation > Dish Setting > Positioner Setting menu,
and then set Positioner to USALS. Specify these items correctly:
• Dish Longitude: Enter the longitude where the dish is located.
• Dish Latitude: Enter the latitude where the dish is located.
Give the dish a test run to see if it works properly. Repeat these steps for
every desired satellite.
1. Choose Go to Reference from Positioner Command for the dish to re-
turn to the reference point.
2. Choose Satellite and choose a target satellite.
3. Choose Tuner and determine which of the dish connectors to use. This
option is not available when Tuner Connection is set to Loop-Through
under Settings > Installation > Dish Setting.
4. Choose Frequency and select any available transponder.
5. Choose Go to to rotate the dish so that it faces the target satellite.
S C 19
To Next Page
Loading...
