• Alarm Confirm Message: With this enabled, a message appears to notify
users that a scheduled recording event will begin in 3 minutes.
• Recording Stop Message: With this disabled, pressing the stop button
stops the current recording immediately without asking for confirma-
tion.
• Extra Recording Time Before Start: It is good to begin recording a few
minutes earlier than the scheduled start time to avoid missing the begin-
ning of a programme. Specify how much earlier the receiver should begin
recording.
• Extra Recording Time After Finish: It is good to finish recording a few
minutes later than the scheduled end time to avoid missing the end of
a programme. Specify how much later the receiver should finish record-
ing.
• TimeShift Start: With this set to Auto, the receiver begins time-shift
recording whenever changing channels. With this set to Manual, press-
ing the pause button begins time-shift recording. With this set to Off,
time-shifting is disabled.
• TimeShift Duration: Specify the maximum duration for time-shift
recording. For example, if this is set to 30 minutes, only the last 30
minutes of the programme are temporarily preserved for playback.
• Playback Position Jump: When playing a recording, users can use the
left and right navigation buttons to skip backward and forward. Spec-
ify the amount of time to skip at a time. With this set to Auto, it varies
from 10 seconds to 4 minutes, depending on running time.
• Playback Numeric Function: When playing a recording, users can use
the numeric buttons to skip to a specific point. With this set to Percent-
age Move, the unit for user-entered numbers is percentage. For example,
to skip to the 35-percent point of the recording, enter “35”. With this set
to Commercial skip, users can enter 0 to 9, and the unit is minute. For
example, to skip forward 5 minutes, enter “5”. To skip backward 1 minute,
enter “0”.
R TV 37
To Next Page
Loading...
