Toa RM-200SF - Page 16

2-8
Chapter 2 NOMENCLATURE AND FUNCTIONS
49. LAN link connectors
Use switching hubs to connect between the LAN
link connector of the VX-3000F. Connect each
of the LAN Links A and B to the same switching
hub*, or to different switching hubs* that have
beenconnectedinstarconguration.
Also, it is possible to interconnect the VX-3000F
units directly using the LAN link connectors A and
B without using switching hubs.
* Contact your TOA dealer for more information
on switching hubs.
Notes
• BesuretoconnectbothconnectorsofAandB.
• After connection completion, press the Reset
key to reactivate the VX-3000F.
50. RS link connectors
Connect the RM-200SF Fireman's Microphone
or RM-300X Remote Microphone to these
connectors.
51. Extension output connectors
Connect these connectors to the Extension input
connector of the VX-3000F in SS mode (with no
built-inDigitalPowerAmplier)forzonenumber
expansion by the VX-3008F or VX-3016F.
52. Extension input connectors
Connect these connectors of the VX-3008F or
VX-3016F set to SS mode to the Extension output
connector of the VX-3000F in normal mode.