6-28
Lower Unit
4st 9.9/15/20 2008
8
7
TB
134213 4 2
1342
GREA
SE
OBMOBM
OBM
5. Install pump case (upper) ass'y 7 on the gear case, and
tighten bolts 8 in two or three steps to specified torque.
Apply grease to interior of pump case liner, and
install pump case (upper) by pushing it down
with hand while turning drive shaft clockwise.
6. Feed gear oil to specified quantity a. "Refer to Chapter 3."
Perform "Inspection of Gear Case (Air
Leakage)" in Chapter 3 if necessary.
Pump Case (Upper) Bolt 8 :
6 N · m (4 lb · ft) [0.6 kgf · m]
E_MFS20C_ch06_081216.qxd 09.1.20 5:27 PM ページ 28