TOHATSU MFS 20C - Adjusting Float Height; Float Height a; Installing Carburetor

Fuel System
4-20
4st 9.9/15/20 2008
8) Installing Carburetor
1. Reverse carburetor removing steps to install.
a
2
1
7) Adjusting Float Height
1. Measure float height as shown, and replace float if out of
specification.
2. Install drain screw, float chamber 1 and cover 2.
Float Height a :
26.2mm (1.0314in)
E_MFS20C_ch04_090105.qxd 09.1.20 5:24 PM ページ 20