IDVisor Smart V2 User Guide Page 26 of 28
Rev 6.1 - December 15, 2020
At the end of the night, or
whenever the unit is near
the charger, it should be
connected to the charger.
Only use the supplied 5V
UBS power supply.
The LED at the top of the
scanner will turn RED when
charging and GREEN when
fully charged.
It takes about 4 hours to
fully charge
Leave unit on charger when not in use.
Baeries will not be overcharged and unit will be ready for portable use at all mes
8 Charging
To Next Page
