Tokheim Quantium 210 - Hydraulic Connections Types; TQP Connections

Document Ref 947571-001 Rev 2 Page 2-7
Quantium 110 & 210 Installation Manual Site Preparation
Vapour
recovery
pipes
End threaded (VR pipe)
Ø1"
Suction pipes
Electrical supply
Riser VR pipe height (Std)
40
55.5
Riser knee height
Suction pipes
Ø1.5"
(Ø40/49)
Dimension shown from the bottom of chassis.
Riser pipe height
70 Min - 90 Max
Dimensions shown from the bottom of base
Riser VR pipe height (Std)
Riser knee height
End threaded (VR pipe)
Vapour
Recovery
pipe
Ø1"
40
Suction pipe
Electrical Supply
55.5
Riser pipe height
Ø1.5"
(Ø40/49)
70 Min - 90 Max
Suction pipes
Q210 Dispenser with TQP (Standard configuration)
2.3 Hydraulic Connections
The suction pipes are accessible from either side of the Dispenser. Different types of
hydraulic connection are available depending on the dispenser configuration.
Please note : If the inlet riser pipe has a female connection, an adaptor must be used
(1.5” or 2”).
If an adaptor is used, the dimensions shown will need to be reduced (maximum 36mm).
2.3.1 TQP CONNECTIONS
Q110 Dispenser with TQP (Standard configuration)
NEW DRAWINGS REQUIRED
NEW DRAWINGS REQUIRED