Document Ref 947571-001 Rev 2 Page 5-19
Quantium 110 & 210 Installation Manual Installation
5.6.3 COMMUNICATIONS WIRING (WWC HEAD ONLY)
Communications wiring will vary according to the different software protocols.
Comms connections are made by either :-
•Direct wiring into a connector on the Comms board
•Wired into a Comms junction box in hydraulic area
DIRECT WIRING INTO CONNECTOR ON COMMS BOARD
1) Follow the instructions given in section 4.7 to access the calculator head. Locate
the Comms board on the mainboard inside the calculator head.
Note : Connectors are either 4-way or 8-way dependent upon software
protocol ordered
2) Use a small screwdriver or similar to open the connector for cable entry.
3) Make the connections according to the correct wiring diagram shown in this
section.
IMPORTANT :- ENSURE THE CORRECT WIRING DIAGRAM IS
FOLLOWED. SCREEN AND UNUSED WIRES MUST BE CUT AS
CLOSE AS POSSIBLE TO CABLE GLANDS. ENSURE WIRING IN
DISPENSER MATCHES WIRING IN KIOSK.
4) Ensure that all tools and unused materials are removed, close the hydraulic
door and lock.
5) Re-instate power to the dispenser and test its operation.
CONNECTOR
ON COMMS
BOARD
4 WAY
CONNECTOR
8 WAY
CONNECTOR
To Next Page
Loading...
