Topcon RM-8800 User Manual

15
COMPONENT NAMES
PRINTER OUTPUT
RM-8800
When measurement is done under the IOL mode, a reliability factor is printed out
following the Ι mark.
The reliability factor is formed with integers 1 to 9 in increasing order of reliability.
Additionally, if the reliability is high enough, the reliability factor is not shown in the
printout.

NAME
〈R〉
S
-0.25 -0.75 88
-0.25 -0.75 90
CYL:(-)
CA
VD:12.00
PD:65
ADD:2.25NPD:61
20030301AM10:00
No.000101
-RM010602-
-0.25 -0.75 90
-0.25 -0.75 90
-0.258
9
-0.75
S.E. -0.75
S.E. -0.75
90
-0.25 -0.75 90
〈L〉
S
+0.25(
)-0.75 88
+0.25
** **
CA
+0.25 -0.75 90
-0.75
90
+0.25
+0.25 -0.75 90
-0.25 -0.75
90
TOPCON
Patient No.
Instrument No.
VD (vertical distance)
Cylindrical power mark
Results of 5 refractory power measurements of
right eye (recordable up to 10 measurements)
Typical value of right eye
Results of 5 refractory power measurements of left eye (recordable
up to 10 measurements)
Typical value of left eye
PD (pupil distance)
Reliability factor
Bar code
Work ID No.
Equivalent spherical power of right eye
The ( ) mark is added when measurement values are not fully
reliable.
The
Ι
mark is displayed at IOL mode.
If the reliability is low and values of C and A cannot be determined,
∗∗ marks are given to pertaining columns.

Topcon RM-8800 Specifications

General

Brand	Topcon
Model	RM-8800
Category	Measuring Instruments
Language	English