67
INDIVIDUAL OPERATIONS
INDIVIDUAL OPERATIONS
PRINT-OUT OF MEASUREMENT VALUES
This instrument is equipped with a built-in printer to print out measurement values.
1 Confirm the measurement screen.
2 Press the of the control panel.
Measurement values of the monitor screen are printed out. After printing, the values are
erased automatically from the monitor screen.
NOTICE
• To avoid paper jam in the printer, do not feed the paper if it is partly
cut/torn or wrinkled.
• To avoid discoloring the printing paper (particularly the recording
area) during storage, use a polypropylene holder and not one con-
taining plasticizer (PVC, etc.).
• To avoid discoloring the printing paper (particularly the recording
area) after pasting, use water soluble glue and not one containing
solvent.
• Since the printer paper is heat sensitive, it is not suitable for record-
ing for a long period. If necessary to keep records for long, we rec-
ommend to take copies separately.
The “ERR” mark is not printed. Also, printing is not done if there is no measure-
ment value. When a red line appears in the printer paper, replace it with new one.
For details about the replacement of printer paper, see “PRINTER PAPER SET-
TING” on page 50. Additionally, a 58mm wide paper roll (example: TF50KS-E2C
[Nippon Paper Co.]) is recommended.
If “PRINTER HEAD UP” is displayed, lower the paper retainer lever and press the
again.
PRINT SWITCH
PRINT SWITCH
To Next Page
Loading...
