19
PREPARATIONS
PREPARATIONS
INST
ALLATION
1
Fasten the clamping knob.
2
Firmly hold the instrument at the specified position and place it on the automatic
instrument table.
For the automatic instrument table, see “OPTIONAL ACCESSORIES” on page 80.
3
After installation, loosen the clamping knob.
Now the main body can be moved.
CAUTION
Before moving the instrument, fasten the clamping knob at the
bottom surface to stop movements. Negligence of this may
cause injury by falling parts.
CAUTION
When moving the instrument, be sure to hold it at the bottom
surface with two persons. Carrying by one person may cause a
backache or injury by falling parts. Also, holding area other
than the bottom surface may cause pinching fingers between
parts and injury by falling parts as well as damage to the
instrument.
CAUTION
To prevent injury due to tumbling of the instrument body and
falling parts, avoid a slope and unstable floor for installation.
RK
AUTO
KERATO-
REFRACTOMETER
.
88
0
0
Holding positions Holding the instrument
Clamping knob
To Next Page
Loading...
Need help?
General
