Topcon RM-8800 User Manual

63
BASIC OPERATIONS
6 After the alignment bar is displayed, move the main body slowly towards the patient.
Measurement is done and the measurement value is displayed on the monitor screen.
DISPLAYING MEASUREMENT VALUES
Data of the latest measurement are displayed on the monitor screen.
Figures only: Measurement was done correctly.
ERROR: Measurement was not done correctly.
• To stop auto start
Press the , and release it after hearing the buzzer
sounds twice. Auto measurement is stopped. To return to auto measurement,
press the again.
After stopping the measurement, the measurement result is printed out by
pressing the .
• To automatically print the measurement result (available at auto start mode
only)
If YES is selected for auto print in the initial setting, press the
after right and left measurements are finished.
The buzzer sounds twice, and the measurement result is printed out automati-
cally.
NOTICE
• If measurement is not possible under auto start mode (this may
occur when the cornea condition is not good), measure under
manual start mode.
For messages on the monitor screen, see “Messages given during measurement”
on page 75.
S + 0.00
+ 0.50
100
C
A
H 43.00
44.00
180
V
A
CYL
VD
12.00
01
0001
(-)
R L
S+ 0.00
+ 0.50 C
A
H43.00
44.00
180
V
A
R
R01 01
K
L
/
01 01
/
m
D
R
K
S + 0.00
+ 0.50
100 100
C
A
H 43.00
44.00
180
V
A
CYL
VD
12.00
01
0001
(-)
R L
S+ 0.00
+ 0.50 C
A
H43.00
44.00
180
V
A
R
R01 01
K
L
/
01 01
/
m
D
R
K
MEASUREMENT SWITCH
AUTO START SWITCH
PRINT SWITCH
MEASUREMENT SWITCH

Topcon RM-8800 Specifications

General

Brand	Topcon
Model	RM-8800
Category	Measuring Instruments
Language	English