Installation On Site SWINGDOOR Smart Drive 1101 T-1132 e 19
7 Commissioning of the
Automatic System
• The sensors, safety facilities and operating devices are professionally installed,
connected and preset.
• The operator is mounted professionally and the linkage is attached.
• The linkage and the internal end stop are adjusted and coordinated.
• The mains cable is expertly laid and connected.
• The system is switched on and is in operating mode AUTO.
• The point LED at the digital display is illuminated.
7.1 Commissioning with “Teach-In General”
During commissioning and in particular during “Teach-In” no people or items may be
present in the swing area of the door!
1. Push simultuaneosly the yellow and the blue key ➞ programming mode is active. (No
number is visible on the digital display yet).
2. Press yellow key once ➞ display 0 is illuminated for max. 5 s.
(function “Teach-In” is now selected)
3. Press blue key once ➞ display 0 flashes
(“Teach-In General” is now ready for execution)
4. Open the door by hand with the desired speed, keep it open as long as desired and
close it with the desired speed (the speeds are limited upward by the motor and the
spring force).
5. Open the door by way of the activator ➞ the operator now opens the door and
reproduces the manually performed operational sequence for opening and displays
the sequence with the numbers 1 to 3 on the digital display.
During this sample opening sequence, the safety device in opening direction is
disabled automatically starting from the door position from where it responds. The
detection of the wall is thereby ignored for all following door openings.
“Teach In” is finished on completion of this test run. The learned values are now
stored. The function is departed automatically.
6. Check the safety facilities in opening and closing direction to find out whether they
react to a test object in the given swing area (see operating instructions T-1134
section 4.2).
Attention: Changing the position of the linkage requires a new Teach-In.
7.2 Programming Procedure
(See table in section 7.4)
Smart Drive 1101 possesses many useful features and parameters. These can be
programmed through 2 keys and a digital display as follows:
• Push simultuaneosly the yellow and the blue key ➞ programming mode is active. (No
number is visible on the digital display yet).
• Select the desired function (1st number) with the yellow key.
• Press the blue key for confirmation of your choice.
➞ 2nd number (parameter) flashes.
• Modify the parameter with the yellow key as desired.
• For storage of the adjusted parameter, press the blue key again.
The procedure is thus complete and the 1st number (function) is displayed again.
Prerequisite
!
T1032/7
8
To Next Page
Loading...