Tormax Automatic Smart Drive 1101 - Programming Examples and Factory Reset; 7.3 Programming Examples Walkthrough; Example 1: Adjusting Opening Time Delay; Example 2: Checking Push and Go Release Angle

20 Installation On Site SWINGDOOR Smart Drive 1101 T-1132 e
If no action takes place for 5 s during programming, the procedure is aborted without
effect. (Return to functions or leaving programming mode). Exceptions are the Teach-
In functions (0), which can be cancelled by prssing the blue key, as long as the door
has not been moved.
The input and outputs are inactive as long as the control system is in the programming
mode.
7.3 Programming Examples
Program the desired functions now in sequence in accordance with the programming
table. The individual functions are described in section 7.4.
Check the programming options immediately after they are set!
Changing the opening time delay to 1.2 s.
• Read values from the programming table.
• Push simultuaneosly the yellow and the blue key ➞ programming mode is active. (No
number is visible on the digital display yet).
• Press the yellow key several times until the number 3 appears on the display
➞ Number 3 is lit (function)
• Press the blue key once for confirmation of the choice
➞ Number 0, or the value programmed last, flashes (parameter)
• Press the yellow key several times until the number 3 appears
➞ Number 3 flashes (parameter)
• Press the blue key once for storage of the adjusted value
➞ Number 3 is lit (function)
Examination of the last programmed value of the release angle for the function
“Push and Go”.
• Push simultuaneosly the yellow and the blue key ➞ programming mode is active. (No
number is visible on the digital display yet).
• Press the yellow key several times until the number 1 appears on the display
➞ Number 1 is lit (function)
• Press the blue key once for confirmation of the choice
➞ The last programmed value is now displayed and is flashing
The value associated with the displayed number can be inferred from the programming
table.
• Wait 5 s
➞ The LED shows no 1 lit
• Wait 5 s
➞ The point LED is lit
(programming was aborted automatically without any changes)
Factory reset
• Push simultuaneosly the yellow and the blue key ➞ programming mode is active. (No
number is visible on the digital display yet).
• Press the yellow key several times until the number 9 appears on the display
➞ Number 9 is lit (function)
• Press the blue key once for confirmation of the choice
➞ Number 0 flashes (parameter)
• Press the yellow key once
➞ Number 1 flashes (parameter)
• Press the blue key once to execute the factory reset
➞ The point LED is lit
Example 2
Example 3
Example 1