12
The “First Setup” page replaces the Homepage until the “First Setup” is done. Verify that the controller reads the
batteries voltage and current. Verify the “AC” is “OK” and not “FAIL”. Verify that the pressure reading is correct.
Before trying to start the engine, verify that the engine setup is complete and the exhaust pipe is connected properly.
Verify that the engine has started and is running properly.
Click on the “Go to Setup” button. The “Config” page is now visible. Click on the “padlock” button to log in with your
password. If needed, read the “User Login / KeyPad” section for more information on how to enter your password.
Once a valid password is confirmed, the “Config” page will be visible again with the “padlock” showing that it is open
the actual user security level.
Once the configuration is done, click on the “Home” membrane button. The “First Setup” page will be displayed
When satisfied with the controller settings, press the "Home" button on the membrane, acknowledge the changes by
pressing the done button. If the done button is unavailable, ensure that a sufficient authorization code has been
entered.
To Next Page
Loading...
Need help?
General
