Adjustments
Throttle Linkage Adjustment
1. Adjust low engine speed to 1250 ± 50 RPM at engine.
2. With the engine off, adjust throttle stop on back side
of control panel so throttle lever on engine goes against
low speed adjustment screw at the same time throttle
lever on control panel bottoms out.
3. Adjust high engine speed to 3200 ± 100 RPM at
engine.
4. With engine off, move throttle control lever on control
panel up to high speed position. Loosen capscrew and
nut securing throttle cable clamp near engine. Pull cable
toward frame until throttle lever on engine is up against
high speed adjustment screw. Tighten capscrew and nut
securing throttle cable clamp.
5. Check to make sure throttle lever on engine goes
against high speed adjustment screw when throttle on
control panel is moved up to high speed position. When
throttle lever on control panel is moved down to low
speed position, throttle lever on engine should go
against low speed adjustment screw at the same time
throttle lever on control panel bottoms out.
Reelmaster
®
216/216-D Page 4 - 3 Adjustments
To Next Page
Loading...
Need help?
General
