Toro 30280 - Maintenance; Recommended Maintenance; Schedule(S)

Maintenance
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst 8 operating
hours
• Change the engine oil.
• Check the hydraulic uid level.
• Change the hydraulic lter.
Before each use or daily
• Check the safety system.
• Grease the front caster pivot bearing.
• Check the engine oil level.
• Clean the air intake screen.
• Check the brakes.
• Inspect the blades.
• Clean the mower deck.
Every 25 hours
• Check the battery electrolyte level.
• Check the hydraulic uid level.
Every 50 hours
• Grease the side bearings.
• Grease the PTO belt idler.
• Grease the mower deck belt idler.
• Check the tire pressure.
• Check the mower belt.
• Check the PTO drive belt.
• Check the pump drive belt.
Every 100 hours
• Change the engine oil.
• Check the spark plugs.
• Adjust the electric clutch.
• Check the hydraulic lines.
Every 200 hours
• Replace the air lter (more often in dirty or dusty conditions).
• Change the oil lter.
• Replace the fuel lter.
• Change the hydraulic lter.
Every 400 hours
• Grease the front wheel bearings (more often in dirty or dusty conditions).
Before storage
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
Yearly
• Lubricate the caster wheel hubs.
Important: R efer to y our Engine Operator’ s Man ual f or additional maintenance pr ocedur es.
If y ou lea v e the k ey in the ignition s witch, someone could accidentl y star t the engine and
seriousl y injur e y ou or other bystander s.
R emo v e the k ey fr om the ignition and disconnect the spar k plug wir es fr om the spar k plugs
bef or e y ou do an y maintenance. Set the wir es aside so that they do not accidentall y contact
the spar k plugs.
26