Toro 30280 - Cleaning; Cleaning under the Mower; Waste Disposal

Figure 80
1. Bolt 5. Spring installed
2. Spacer
6. Grass Deector
3. Locknut 7. L end of spring, place
behind deck edge before
installing bolt
4. Spring
8. J hook end of spring
2. Place spacer and spring onto g rass deflector .
Place the L end of spring behind dec k edg e .
Note: Mak e sure the L end of spring is
installed behind dec k edg e before installing the
bolt as sho wn in Figure 80 .
3. Install bolt and n ut. Place the J hook end of
spring around g rass deflector ( Figure 80 ).
Important: T he g rass deflector must be
a ble to r otate. Lift the deflector up to the
full open position and ensur e that it r otates
into the full do wn position.
Cleaning
Cleaning Under the Mower
R emo v e the g rass buildup under the mo w er daily .
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Raise the front of the mac hine and use jac k
stands to suppor t the mo w er .
Waste Disposal
Engine oil, batteries , h y draulic oil, and engine
coolant are pollutants to the en vironment.
Dispose of these according to y our state and local
regulations .
56