Figure 38
1. Fuel shut-off valve 2. Clamp
Servicing the Fuel Filter
R e place the fuel filter after ev er y 200 operating
hours or yearly , whic hev er occurs first.
Replacing the Fuel Filter
Nev er install a dir ty filter if it is remo v ed from the
fuel line .
Note: Note ho w the fuel filter is installed in
order to install the new filter cor rectly .
Note: Wipe up any spilled fuel.
1. Diseng ag e the PTO and set the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Close fuel shut-off v alv e at the fuel tank
( Figure 38 ).
4. Squeeze the ends of the hose clamps tog ether
and slide them a w a y from the filter ( Figure 39 ).
Figure 39
1. Hose clamp 3. Filter
2. Fuel line
5. R emo v e the filter from the fuel lines .
6. Install a new filter and mo v e the hose clamps
close to the filter .
7. Open fuel shut-off v alv e at fuel tank
( Figure 38 ).
8. Chec k for fuel leaks and re pair if needed.
9. Wipe up any spilled fuel.
Electrical System
Maintenance
Servicing the Battery
Chec k the electrolyte lev el in the batter y ev er y
25 hours . Alw a ys k ee p the batter y clean and fully
c harg ed. Use a paper to w el to clean the batter y
case . If the batter y ter minals are cor roded, clean
them with a solution of four par ts w ater and one
par t baking soda. Apply a light coating of g rease
to the batter y ter minals to prev ent cor rosion.
V oltag e: 12 V
33
To Next Page
Loading...
