EasyManua.ls Logo

Toro 30308 - Page 19

Toro 30308
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 8
1. Vent caps
3. Carefully fill eac h cell with electrolyte until the
plates are co v ered with about 1/4 inc h (6 mm)
of fluid ( Figure 9 ).
Figure 9
1. Electrolyte
4. Allo w appro ximately 20 to 30 min utes for the
electrolyte to soak into the plates . R efill as
necessar y to bring the electrolyte to within
about 1/4 inc h (6 mm) of the bottom of the
fill w ell ( Figure 9 ).
Charging the batter y pr oduces gasses
that can explode.
Nev er smok e near the batter y and k eep
spar ks and flames a w ay fr om batter y .
5. Connect a 3 to 4 amp batter y c harg er to the
batter y posts . Charg e the batter y at a rate of 3
to 4 amps until the specific g ra vity is 1.250 or
higher and the temperature is at least F . (16°C)
with all cells g asing freely .
6. W hen the batter y is c harg ed, disconnect the
c harg er from the electrical outlet and batter y
posts .
Note: After the batter y has been acti v ated,
add only distilled w ater to re place nor mal loss ,
although maintenance-free batteries should
not require w ater under nor mal operating
conditions .
Warning
CALIFORNIA
Pr oposition 65 W ar ning
Batter y posts, ter minals, and r elated
accessories contain lead and lead
compounds, chemicals kno wn to the
State of Calif or nia to cause cancer and
r epr oducti v e har m. W ash hands after
handling .
Batter y ter minals or metal tools could
shor t a gainst metal tractor components
causing spar ks. Spar ks can cause the
batter y gasses to explode, r esulting in
per sonal injur y .
W hen r emo ving or installing the
batter y , do not allo w the batter y
ter minals to touch an y metal par ts of
the tractor .
Do not allo w metal tools to shor t
betw een the batter y ter minals and
metal par ts of the tractor .
7. Install the batter y into the mac hine .
8. First, install the positi v e cable (red) to the
positi v e (+) ter minal and then the neg ati v e
cable (blac k) to the neg ati v e (-) ter minal of
the batter y ( Figure 10 ). Slide the r ubber boot
o v er the positi v e ter minal to prev ent a possible
shor t from occur ring .
19

Table of Contents

Other manuals for Toro 30308

Related product manuals