Toro 30308 - Maintenance; Recommended Maintenance; Schedule(S)

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst 10
operating hours
• Check the service brake adjustment.
• Change the hydraulic oil lter.
After the rst 50
operating hours
• Change the engine oil and lter.
Before each use or daily
• Check the engine oil level.
• Check the cooling system.
• Check the hydraulic uid level.
• Drain the water separator.
• Check and clean the radiator and screen.
• Check the level of the hydraulic oil.
Every 50 hours
• Grease the bearings and bushings.
• Check the battery electrolyte level.
Every 150 hours
• Change the engine oil and lter.
• Check the condition and tension of the alternator belt.
• Replace the hydraulic oil lter.
Every 400 hours
• Check the fuel lines and connections.
Every 450 hours
• Service the air cleaner.
• Replace the fuel lter canister.
• Clean the fuel tank.
• Replace the fuel pre lter.
• Change the rear axle lubricant (Model 30309 only).
• Change the bidirectional clutch lubricant (Model 30309 only).
Every 500 hours
• Grease the rear axle bearings.
Every 1,500 hours
• Replace the hydraulic oil.
Yearly
• Grease the check valve pins.
If y ou lea v e the k ey in the ignition s witch, someone could accidentl y star t the engine and
seriousl y injur e y ou or other bystander s.
R emo v e the k ey fr om the ignition bef or e y ou do an y maintenance.
38