2. R otate the clutc h ( Figure 26 ) so that the c hec k
plug (sho wn in the 12 o’cloc k position) is
positioned at 4 o’cloc k.
Figure 26
1. Bidirectional clutch 2. Check plug
3. R emo v e the c hec k plug .
T he fluid lev el should be up to the hole in the
clutc h. If the fluid lev el is lo w , add Mobil Fluid
424. T he clutc h should be appro ximately 1/3
full.
4. Install the c hec k plug .
Note: Do not use engine oil (i.e . 10W30) in
the bidirectional clutc h. Anti-w ear and extreme
pressure additi v es will cause undesirable clutc h
perfor mance .
Note: Deter mine the left and right sides
of the mac hine from the nor mal operating
position.
Using the Rollover
Protection System (ROPS)
T o a v oid injur y or death fr om r ollo v er : k eep
the r oll bar in the raised lock ed position and
use the seat belt.
Ensur e that the r ear par t of the seat is
secur ed with the seat latch.
T her e is no r ollo v er pr otection when the r oll
bar is in the do wn position.
• Lo w er the r oll bar onl y when a bsolutel y
necessar y .
• Do not w ear the seat belt when the r oll
bar is in the do wn position.
• Dri v e slo wl y and car efull y .
• R aise the r oll bar as soon as clearance
per mits.
• Check car efull y f or o v erhead clearances
(i.e. branches, doorw ays, electrical wir es)
bef or e dri ving under an y objects and do
not contact them.
• Lo w er r oll bar slo wl y so dama ge to hood
does not occur .
Important: Lo w er the r oll bar onl y when
a bsolutel y necessar y .
1. T o lo w er the roll bar , remo v e the hair pin cotter
pins and remo v e the tw o pins ( Figure 27 ).
Figure 27
1. Roll bar
3. Hairpin cotter pin
2. Pin
2. Lo w er the roll bar to the do wn position.
3. Install the tw o pins and secure them with the
hair pin cotter pins ( Figure 27 ).
32
To Next Page
Loading...
