Toro 34225 - Page 29

To Next Page

To Previous Page

ConnectingtheRate-GateLinkage

1.Pullthelinkageoutuntilitclearsthedrop-rate

cam(Figure30).

2.Movethewide-distributionimpeller-gatelever

forward.

3.Attachingthecabletotheballstudatthegate

lever(Figure30).

AssemblingtheImpeller

1.Assembleimpellerontotheimpellershaftand

securetheimpellerwiththedrivepin.

2.Aligntheholesinthefrontcoverwiththeclip

nutsinthechassisandsecurethecoverwith

the4thumbscrewsthatyouremovedinstep3

ofRemovingtheImpeller(page27).

Main Page

Table of Contents3
Safety4
General Safety4
Safety and Instructional Decals4
Setup9
Checking the Tire Air Pressure9
Checking the Engine-Oil Level9
Checking the Transaxle-Fluid Level9
Connecting the Battery10
Product Overview10
Controls11
Machine Controls11
Spreader Controls13
Sprayer Controls15
Specifications16
Before Operation17
Before Operation Safety17
Performing Daily Maintenance18
Checking the Safety Interlock System18
Fuel Specification18
Using Stabilizer/Conditioner18
Filling the Fuel Tank19
During Operation19
During Operation Safety19
Operating the Machine21
Operating the Spreader24
Operating the Sprayer35
After Operation43
After Operation Safety43
Cleaning and Lubricating the Spreader44
Cleaning the Sprayer45
Transporting the Machine47
Maintenance49
Maintenance Safety49
Recommended Maintenance Schedule(S)49
Notation for Areas of Concern50
Pre-Maintenance Procedures50
Preparing the Machine51
Lubrication51
Lubricating the Grease Fittings51
Engine Maintenance52
Servicing the Air Cleaner52
Engine Oil Specification52
Checking the Engine-Oil Level53
Changing the Engine Oil53
Servicing the Spark Plug55
Cleaning the Spark Arrester55
Fuel System Maintenance56
Draining the Fuel System56
Electrical System Maintenance57
Servicing the Battery57
Removing and Installing the Battery59
Jump-Starting the Machine60
Servicing the Fuses61
Drive System Maintenance62
Checking the Air Pressure in the Tires62
Torqueing the Axle Bolts62
Aligning the Front Wheels62
Servicing the Transaxle63
Controls System Maintenance64
Adjusting the Pattern Control Cable for the Spreader64
Maintaining the Chassis65
Checking the Machine for Loose Hardware65
Maintaining the Sprayer System66
Checking Sprayer System66
Cleaning66
Cleaning the Engine and the Exhaust System Area66
Cleaning the Debris from the Machine66
Removing the Engine Shroud and Cleaning the Cooling Fins66
Waste Disposal67
Storage67
Preparing the Machine for Extended or Winter Storage67
Troubleshooting69
Schematics73

Toro 34225 - Page 29

Table of Contents

Related product manuals