Toro 74950 - Adjusting the Height-of-Cut Pin; Adjusting the Anti-Scalp Rollers

AdjustingtheHeight-of-CutPin
Theheightofcutisadjustedfrom25to140mm(1to5–1/2
inches)in6mm(1/4inch)incrementsbymovingtheclevis
pinintodifferentholelocations.
1.Movethetransportlocktothelockposition.
2.Pushonthedeck-liftpedalwithyourfootandraisethe
mowerdecktothetransportposition(alsothe140mm
(5–1/2inch)cutting-heightposition);refertoFigure
27.
3.Toadjust,rotatethepin90°andremovethepinfrom
theheight-of-cutbracket(Figure27).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheightofcutdesired,andinsertthepin(Figure
27).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
Figure27
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheightofcut,itisrecommendedto
adjusttheheightoftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition,
andsettheparkingbrake.
2.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Adjusttheanti-scalprollersasshowninFigure28,
Figure29,andFigure30.
g029955
Figure28
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
g029956
Figure29
1.Anti-scalproller3.Flangenut
2.Bushing4.Bolt
g029957
Figure30
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
25