Toro 74950 - Brake Maintenance; Adjusting the Parking Brake

BrakeMaintenance
AdjustingtheParkingBrake
ServiceInterval:Aftertherst100hours(Orwhena
brakecomponenthasbeenremovedor
replaced).
Every500hours
Checktomakesurethatthebrakeisadjustedproperlybefore
adjusting.
1.Drivethemachineontoalevelsurface.
2.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition,
andengagetheparkingbrake.
3.Stoptheengine,waitforallmovingpartstostop,and
removethekey.
4.Raisethebackofthemachineupandsupportthe
machinewithjackstands.
DANGER
Mechanicalorhydraulicjacksmayfailto
supportmachineandcauseaseriousinjury.
•Usejackstandwhensupportingmachine.
•Donotusehydraulicjacks.
5.Removethereartiresfromthemachine.
6.Removeanydebrisfromthebrakearea.
7.Rotatethedrive-wheel-releasehandletothereleased
position.
8.Checktoseeifthereisavisiblegapbetweenthe
L-bracketandthelinkagestop(Figure74).
Figure74
LeftSideShown
1.L-bracket4.Rearlinkageassembly
2.Linkagestop
5.Caliper
3.Gap
6.Wheelhub
9.Disengagetheparkingbrake,thelevershouldbein
thedownposition.
10.Turnthewheelhubbyhandinbothdirectionsrelative
tothecaliper;thewheelhubshouldmovefreely
betweenthecaliper.
11.Ifagapisneededorthewheelhubdoesnotmove
freely:
A.Disengagetheparkingbrake.
B.Disconnectandne-tunetherearlinkage
assembly:
•Shortenthelinktocreateagap.
•Lengthenthelinktoallowwheelhub
movement.
C.Reconnecttherearlinkageassembly.
12.Engagetheparkingbrakeandcheckthegap.
13.Repeatsteps9through13untilavisiblegapisachieved
andthewheelhubrotatesfreely.
14.Repeatthisprocedureforthebrakeontheopposite
side.
15.Rotatethedrive-wheel-releasehandletotheoperating
position.
16.Installthereartiresandtorquethelugnuts;referto
CheckingtheWheelLugNuts(page44).
17.Removethejackstands.
48