Toro GT series - Page 107

CHASSIS
 GT Series Tractors Service Manual
3
 +RRNWKHGHFNOLIWVSULQJRQWRWKHIUDPH)LJ
Fig 342 3,&7
8. Place the deck lift handle in the lowest height-of cut
position.
 ,QVHUWWKHORZHUHQGRIWKHOLIWFDEOHWKURXJKWKH
hole in the frame located in front of the roller pulley
EUDFNHW)LJ
Fig 343 3,&7
 ,QVHUWWKHVKRXOGHUEROWLQWRWKHUROOHUSXOOH\3ODFH
the lift cable into the groove of the roller pulley. Insert
WKHVKRXOGHUEROWUROOHUDVVHPEO\LQWRWKHSXOOH\
EUDFNHWORFDWHGRQWKHIUDPH)LJ
Note: Make sure the cable stays inside the guides
RQWKHIUDPH
Fig 344 3,&7
11. Install a nut onto the shoulder bolt to secure the
UROOHUSXOOH\DQGOLIWFDEOHWRWKHIUDPH)LJ
Fig 345 3,&7