GEAR DRIVE SYSTEM
5-28 GT Series Tractors Service Manual
5
Differential Axle Assembly Service
Note: Differential is serviced as an assembly.
23. Remove the bolt and washer securing the wheel hub
assembly to the transmission axle shaft. Remove the
wheel hub from the axle shaft (Fig. 530).
Note: Discard the bolt. It is a patch bolt and must be
replaced upon installation.
24. Slide the 2 bearings off the axle (Fig. 531).
Fig 530 PICT-8314a
Fig 531 PICT-8315a
27. Slide 2 bearings onto the axle shaft (Fig. 533).
25. Repeat steps 23 and 24 to remove the opposite
bearings and wheel hub assembly.
26. Inspect the 4 bearings. Replace if worn or damaged
(Fig. 532).
Fig 533 PICT-8315a
Fig 532 PICT-8318a
To Next Page
Loading...
