GEAR DRIVE SYSTEM
5-22 GT Series Tractors Service Manual
5
CVT Transmission Service
CVT Transmission Housing Teardown
26. Install 4 screws securing the shift cover to the frame
(Fig. 506).
28. Install the transmission drive belt. Refer to “Trans-
mission Drive Belt Installation” on page 5-3.
29. Install the mower deck. Refer to “50” Mower Deck
Installation” on page 7-8.
30. Operate the tractor to ensure all controls operate
properly.
Fig 506 PICT-7712
2. Remove the upper housing from the lower housing
assembly (Fig. 509).
27. Slide the shift knob onto the shift rod (Fig. 507).
Fig 509 PICT-8274a
Fig 507 PICT-7632
Note: Transaxle shown does not have grease, for
photo clarity. Clean and inspect all parts after
disassembly. Apply a small amount of grease
to all moving parts and needle bearings prior
to reassembly.
1. Remove the 23 bolts securing the housing halves
together (Fig. 508).
Fig 508 PICT-8272a
To Next Page
Loading...
