Toro GT series - Page 44

CHASSIS
GT Series Tractors Service Manual
3
 /RZHUWKHPDFKLQH
 3XOOWKHVWHHULQJVKDIWXSDQGRXWRIWKHKH[ÀDQJH
bearing. Angle the steering shaft between the pedal
OHYHOHUVDQGORZHULWRXWRIWKHWRZHU)LJ
 ,QVWDOOWKHKH[ÀDQJHEXVKLQJLQWRWKHVWHHULQJ
support bracket ensuring the hex is seated in the
EUDFNHW)LJ
Fig 101 3,&7
Fig 103 3,&7
2. Slide the steering shaft up into the tower from below.
Insert the lower end of the steering shaft into the hex
ÀDQJHEXVKLQJ)LJ
 5HPRYHWKHKH[ÀDQJHEXVKLQJIURPWKHVWHHULQJ
VKDIWVXSSRUWEUDFNHW)LJ
1RWH ,QVSHFWWKHKH[ÀDQJHEXVKLQJDQGUHSODFHLW
LIZRUQRUGDPDJHG
Fig 104 3,&7
Fig 102 3,&7
6WHHULQJ6KDIW,QVWDOODWLRQ