Toro ProLine H800 - Adjusting the Height of Cut; Adjusting the Skids; Adjusting the Front Anti-Scalp Roller

g224571
Figure28
1.Positionthehoppersensor
upwardwhengrassisthin
orconditionsaredry.
3.Positionthehoppersensor
downwardwhengrassis
thick,containsleaves,or
conditionsarewet.
2.Positionthehoppersensor
inthemiddlewhengrass
andweatherconditions
arenormal.
AdjustingtheHeightofCut
Youcanadjusttheheightofcutcontinuallyfrom
20to110mm(3/4to4-1/4inches)byusingthe
height-of-cutswitch.
Pushtheheight-of-cutswitch(Figure8)forwardto
lowertheheightofcut.Pushtheheight-of-cutswitch
rearwardtoincreasetheheightofcut.
Readtheheightofcutindicatorontheheight-of-cut
gaugetoensurethatitissetatthedesiredheight.
Monitortheheight-of-cutgaugeasyoumowand
adjusttheheightofcutifneeded.
AdjustingtheSkids
Mounttheskidsinthelowerpositionwhenoperating
atheightsofcutgreaterthan51mm(2inches)and
inahigherpositionwhenoperatingatheightsofcut
lowerthan51mm(2inches).
AdjusttheskidsasshowninFigure29.
g035646
Figure29
AdjustingtheFront
Anti-ScalpRoller
Mounttherollerinthelowerpositionwhenoperating
atheightsofcutgreaterthan51mm(2inches)and
inahigherpositionwhenoperatingatheightsofcut
lowerthan51mm(2inches).
1.Parkthemachineonalevelsurface.
33