Toro Z Master Z400 Series - Page 108

5-21Z Master Z400 Service Manual
5
ENGINE
15. Connect the fuel hose clamp onto the fuel hose at
the fuel pump (Fig. 284).
Fig 284 PICT-0282
16. Turn the fuel shut-off valve to the “on” position (Fig.
285).
Fig 285 PICT-0281
Fig 287 PICT-0294
b. Reconnect the z-bend of the throttle cable to the
throttle linkage (the hole furthest from the pivot
point). Pull the cable housing until the throttle
linkage is in the full throttle position. Tighten the
cable clamp (Fig. 287).
Fig 286 PICT-0293
17. Reconnect the throttle cable:
a. Position the throttle control lever so that there is
approximately1/2”(12.7mm)betweenthelever
and the full throttle position of the throttle slot
(Fig. 286).
1/2”