3. REPLACING THE IMPORTANT PARTS EO18-33025
(Revision Date: Mar. 27, 2009)
3.4 Replacing the Platen Ass’y
3-9
3.4 Replacing the Platen Ass’y
1. Refer to section 3.1 to open the top cover.
2. Release the platen holder tabs from the lower inner cover and vertically raise them.
3. Remove the platen ass’y.
4. Replace the platen ass’y with a new one, then reassemble in the reverse order of
removal.
5. After replacing, perform a diagnostic test print or print a sample label to make sure the
printer performs correctly for the following points.
• The label is issued correctly.
• No noise is generated during the print operation.
• None of blurred print, smudge, etc. is generated.
Platen Holder Tab
Platen Ass’y
To Next Page
Loading...
