Toshiba B-EV4 Series - Replacing the Black Mark Sensor

3. REPLACING THE IMPORTANT PARTS EO18-33025
(Revision Date: Mar. 27, 2009)
3.11 Replacing the Black Mark Sensor
3-22
3.11 Replacing the Black Mark Sensor
1. Refer to section 3.1 to remove the top cover.
2. Remove the sensor connector from the main PC board.
3. Use the Phillips screwdriver to remove the 2 screws from the mylar sheet.
4. Remove the mylar sheet.
5. Use the Phillips screwdriver to remove the screw from the sensor plate.
6. Remove the sensor plate.
7. Remove the black mark sensor.
Sensor Connector (JP17)
Main PC Board
T-1.5x4 Screw
Sensor Plate
Mylar Sheet
Black Mark Sensor
FLT-3x6 Screw