6. SYSTEM MODE EO18-33025
(Revision Date: Mar. 27, 2009)
6.4 SENSOR ADJUSTMENT
6-3
6.4 SENSOR ADJUSTMENT
Adjust the sensor to the proper position and set the label or tag paper.
When the STATUS lamp lights in red during the system mode, releasing the [FEED] button performs an
auto sensor adjustment and measurement of the label length.
For the details of the sensor adjustment, refer to the Owner’s Manual.
6.5 DIAGNOSTIC TEST PRINT/DUMP MODE
When the STATUS lamp lights in green during the system mode, releasing the [FEED] button makes a
Diagnostic Test Print and the printer goes into the dump mode.
PRINTER INFO.
PROGRAM VERSION V1.0C 0A9D
TONE ADJUST +00
FEED ADJUST +0.0mm
CUT POSITION ADJUST +0.0mm
BACKFEED ADJUST +0.0mm
PARAMETER [ PC-850 ] [ 0 ]
[ 9600 ] [ 8 ] [ 1 ] [ NONE ] [ 2 ]
[ ON ] [ AUTO ] [ FEED ] [ B0 ]
X-COORDINATE ADJUST +0.0mm
SENSOR SELECTION TRANSMISSIVE
SENSOR ADJ. VALUE TRANSMISSIVE [19] REFLECTIVE [47]
PRINT SPEED 5 IPS
FLASH ROM 4 MB
SDRAM 8 MB
USER MEMORY [ 704 KB][ 0 KB]
TTF AREA [ 0 KB][ 0 KB]
EXT CHAR AREA [ 0 KB][ 0 KB]
BASIC AREA [ 0 KB][ 0 KB]
PC SAVE AREA [ 704 KB][ 0 KB]
INFORMATION B-EV4-Gx-QM 00000000001
TOTAL FEED 0.0 km
TOTAL PRINT 0.0 km
TOTAL CUT 0
IP ADDRESS 192.168.10.20
SUBNET MASK 255.255.255.0
GATEWAY 0.0.0.0
MAC ADDRESS 00-1B-82-FF-0C-E8
DHCP Disabled
DHCP CLIENT ID FFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFF
SOCKET COMM. Enabled
SOCKET COMM. PORT 8000
Test Print Sample
To Next Page
Loading...
