4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
(Revision Date: Aug. 24, 2011)
4.3 PEEL-OFF MODULE (B-EX904-H-QM-R)
4-18
4. Insert the connector of the Rewinder Harness, disconnected from the Rewinder PC Board in Step 2, into
the hole in the main frame.
5. Pull out the Rewinder Harness from the opposite side, and re-connect it to CN1 on the Rewinder PC
Board.
Rewinder Harness
Hole
Rewinder Harness
CN1
Rewinder PC Board
Hole
Tabs of Blind Plate
(→ Step 7)
To Next Page
Loading...
