Toshiba B-EX4 - Page 68

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
(Revision Date: Aug. 24, 2011)
4.10 UHF RFID KIT (B-EX700-RFID-U2-US/EU/CN-R)
4-53
2. Secure the Antenna to the Antenna Frame with the two SMW-3x6 screws in the following orientation.
3. Attach the Antenna Shield Plate A to the Antenna Frame with the two SMW-3x6 screws, as shown
below.
4. Attach the Antenna Shield Plate B to the Antenna Frame with the SMW-3x6 screw, as shown below.
A
ntenna Cable
A
ntenna Frame
A
ntenna
SMW-3x6
SMW-3x6
SMW-3x6
A
ntenna Shield Plate B
CAUTION! Be sure to pass the Antenna Cable through the slit of the Antenna Frame indicated with
the arrow. Failure to do this may damage the Antenna Cable.
SMW-3x6
A
ntenna Shield Plate
A